NETGEAR GC110 User Manual

Manage Device Security
245
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
You can select from the following ACL types:
• ACL Based on Destination MAC. Creates an ACL based on the destination MAC
address, destination MAC mask, and VLAN.
• ACL Based on Source MAC. Creates an ACL based on the source MAC address,
source MAC mask, and VLAN.
• ACL Based on Destination IPv4. Creates an ACL based on the destination IPv4
address and IPv4 address mask.
• ACL Based on Source IPv4. Creates an ACL based on the source IPv4 address and
IPv4 address mask.
• ACL Based on Destination IPv6. Creates an ACL based on the destination IPv6
prefix and IPv6 prefix length.
• ACL Based on Source IPv6. Creates an ACL based on the source IPv6 prefix and
IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port. Creates an ACL based on the destination
IPv4 Layer 4 port number.
• ACL Based on Source IPv4 L4 Port. Creates an ACL based on the source IPv4
Layer 4 port number.
• ACL Based on Destination IPv6 L4 Port. Creates an ACL based on the destination
IPv6 Layer 4 port number.
• ACL Based on Source IPv6 L4 Port. Creates an ACL based on the source IPv6
Layer 4 port number.
Note: For L4 port options, two rules are created (one for TCP and one for UDP).
7. In the Sequence Number field, enter a whole number in the range of 1 to 2147483647 that
is used to identify the rule.
8. From the Action menu, select Permit or Deny to specify the action that must be taken if a
packet matches the rule’s criteria.
If a packet matches a rule with a permit action, the packet is allowed to continue toward
its destination. If a packet matches a rule with a deny action, the packet is dropped.
9. From the Match Every menu, select one of the following options:
• False. Signifies that packets do not need to match the selected ACL and rule. With
this selection, you can add a destination MAC address, destination MAC mask, and
VLAN.
• True. Signifies that all packets must match the selected ACL and rule and are either
permitted or denied. In this case, since all packets match the rule, you cannot
configure other match criteria.
10. Specify the additional match criteria for the selected ACL type.

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries