To Next Page

To Previous Page

Configure Switching

112

Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports

Set the LACP System Priority

The LACP configuration page is used to set the LACP system priority.

 To configure LACP:

1. Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or

connect directly to a switch that is off-network using an Ethernet cable.

2. Launch a web browser.

3. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Access the Switch on page 13.

The login window opens.

4. Enter the switch’s password in the password field.

The default password is password. If you added the switch to a network on the Insight

app before and you did not yet change the password through the local browser interface,

enter your Insight network password.

The System Information page displays.

5. Select Switching> LAG > Advanced > LACP Configuration.

The LACP Configuration page displays.

6. In the LACP System Priority field, specify the device’s link aggregation priority relative to

the devices at the other ends of the links on which link aggregation is enabled.

A higher value indicates a lower priority. You can change the value of the parameter

globally by specifying a priority from 1 to 65535. The default value is 32768.

7. Click the Apply button.

Your settings are saved.

Set the LACP Port Priority Settings

The LACP port configuration page is used to configure the LACP priority value for the selected

port and the administrative LACP time-out value.

 To configure LACP port priority settings: