Getting Started
19
Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
6. You can now add the switch. Choose one of the following options:
• Tap Switch as the device type and follow the prompts to scan the network.
• Scan the QR code.
• Scan the serial number bar code.
• Type in the serial number.
Note: Screens might display and suggest that you connect the switch to
power and to an uplink. Since the switch is already connected to your
network, on these screens, tap the NEXT button.
7. If the switch is not yet connected to the same WiFi network as your mobile device, connect
it now to the same WiFi network, wait two minutes, and then tap the NEXT button.
The IP address of the switch displays in the device list.
8. Write down the IP address for future use.
9. Launch a web browser.
10. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
11. When prompted, enter the password.
The default password is password. Because you added the switch to a network on the
Insight app before and you did not yet change the password through the local browser
interface, enter your Insight network password.
12. Click the Login button.
A notification displays.
13. Click the OK button to close the notification.
The System Information page displays.
14. Select the Direct Connect Web-browser Interface radio button.
15. Click the Apply button.
Your settings are saved.
The System Information page closes, any current Insight-manageable device settings are
saved to the cloud server, and the login window displays again.
16. When prompted, enter the password.
Because you added the switch to a network on the Insight app before and you did not yet
change the password through the local browser interface, enter your Insight network
password.
The System Information page displays and the full local browser interface is now
available.
To Next Page
Loading...
Need help?
General
