Configure System Information
96
Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
The default is Disable.
8. From the Circuit ID Mode menu, select to enable the interface number to be added as the
circuit ID in DHCP option 82 or to disable the interface number from being added as the
circuit ID in DHCP option 82.
The default is Disable.
9. In the Remote ID String field, enter a remote ID description of up to 32 characters.
10. Click the Apply button.
Your settings are saved.
Configure the DHCP L2 Relay Interface Settings
You can configure the DHCP L2 relay interface settings.
 To configure the DHCP L2 relay interface settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 13.
The login window opens.
4. Enter the switch’s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5. Select Systemï€ > Services > DHCP L2 Relay > DHCP L2 Relay Interface Configuration.
The DHCP L2 Relay Interface Configuration page displays.
6. To display information for all ports and LAGs, click the All link.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the heading
row.
8. From the Admin Mode menu, select to enable or disable the DHCP L2 relay on the
selected interface.
To Next Page
Loading...
Need help?
General
