NETGEAR M4350 Series - Page 52

1
3
2
6
5
7
8
9
10
4
Figure 16. Package contents for an M4350 series half-width model
To check the package contents:
1.
Place the container on a clean flat surface, and cut all straps securing the container.
2.
Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4.
Verify that the package contains the following items:
ItemNumber
Switch of the model that you ordered
Note: Rubber protection caps are installed in the SFP sockets. If you install an SFP transceiver
module, you must remove the cap from the SFP socket.
1
AC power cable or cables (varies by region)2
Type-C USB console cable3
Hardware Installation Guide52Installation
Fully Managed Switches M4350 Series