To enable Plugged-In Mode for fixed usage:
1. Remove the mobile hotspot back cover by lifting the corners.
2. Remove the battery.
NOTE: When using Plugged-In Mode, we recommend that you do not
reinstall the back cover after removing the battery for better device cooling
performance.
3. Connect the USB charging cable to your mobile hotspot.
4. Connect the other end of the charging cable to the USB power adapter.
5. Plug the USB power adapter into a wall outlet.
Power on your hotspot and finish
setup
After configuring your mobile hotspot for travel or fixed usage, power on the device to
complete the setup process.
NOTE: When idle, the touch screen goes dark to save power. Quickly press and
release the Power button to wake the screen.
To power on your hotspot and finish setup:
1. Press and hold the Power button for two seconds.
The NETGEAR logo displays and your mobile hotspot starts up.
The welcome screen displays.
2. Tap Let's go.
3. Follow the onscreen instructions to set up a unique WiFi network name, WiFi
password, and admin password.
Customizing your WiFi settings helps to protect your mobile hotspot’s WiFi network.
NOTE: If you don't customize your the settings, your device uses the WiFi
network name, WiFi password, and admin password printed on the label
underneath the battery.
4. Tap Got it.
The You're all set! screen displays to confirm your configuration.
5. Tap Go to my dashboard.
The home screen displays.
Your mobile hotspot is set up.
User Manual16Overview and Setup
Nighthawk M6 Pro, Nighthawk M6
To Next Page
Loading...
Need help?
General
