Return the router or satellite to its factory
default settings
Under some circumstances (for example, if you lost track of the changes that you made
to the router or satellite settings or you move the router to a different network), you
might want to erase the configuration and reset the router or satellite to its factory default
settings.
To reset the router or satellite to its factory default settings, you can use either the Reset
button on the back of the router or satellite or the Erase function.
After you reset the router to factory default settings, the user name is admin, the
password is password, the LAN IP address is 192.168.1.1 (which is the same as
www.routerlogin.net), and the DHCP server is enabled.
NOTE: If the router is in access point mode or bridge mode and you do not
know the IP address that is assigned to it, first try to use an IP scanner
application to detect the IP address. (IP scanner applications are available
online free of charge.) If you can detect the IP address, you don’t need to reset
the router to factory default settings.
Use the Reset button
CAUTION: If you use the Reset button on the router, the process erases all
settings that you configured on the router
To reset the router or satellite to factory default settings:
1.
On the back of the router or satellite, locate the Reset button.
2.
Using a straightened paper clip, press and hold the Reset button for at least five
seconds.
3.
Release the Reset button.
When the reset is complete, the router or satellite restarts. This process takes about
two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt
the reset. Do not turn off the router or satellite. Wait until the router or
satellite finishes restarting.
User Manual123Manage your Router and
Satellite
Nighthawk Tri-band Mesh WiFi 6E
To Next Page
Loading...
