NETGEAR MR90 - Log in to the Router

• Make sure that the computer is connected to an Ethernet port on the router or
satellite or to the mesh WiFi network.
• Make sure that the router is receiving power and that its Router LED is lit.
• Close and reopen the browser or clear the browser cache.
• Browse to http://www.routerlogin.net.
• If the computer is set to a static or fixed IP address (this setting is uncommon),
change it to obtain an IP address automatically from the router.
6.
If the router does not connect to the Internet, do the following:
a.
Review your settings. Make sure that you selected the correct options and typed
everything correctly.
b.
Contact your ISP to verify that you are using the correct configuration information.
c.
Read Troubleshooting on page 148.
If problems persist, register your NETGEAR product and contact NETGEAR
Technical Support.
Log in to the router
When you first connect to your router and launch a web browser, the browser
automatically displays the router web interface. If you want to view or change settings
for the router later, you can use a browser to log in to the router web interface.
To log in to the router:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
NOTE: You can also enter http://www.routerlogin.com or
http://192.168.1.1. The procedures in this manual use
http://www.routerlogin.net.
A login window opens.
3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
User Manual20Connect to the Network and
Access the Router
Nighthawk Tri-band Mesh WiFi 6E