9.
From the Protocol menu, select the protocol.
If you are unsure, select TCP/UDP.
10.
In the External port range field enter the port range.
11.
Specify the internal ports by one of these methods:
• Leave the Use the same port range for Internal port check box selected.
• Type the port numbers in the Internal Starting Port field and the Internal Ending
Port field.
You can enter a port range and fixed ports in one rule, for example, external (30–50,
78, 100–102), internal (40–60, 99, 200–202). With this rule, external ports 30–50 are
forwarded to internal ports 40–60.
12.
In the Internal IP address field, type the IP address or select the radio button for an
attached device listed in the table.
13.
Click the Apply button.
The service is now in the list on the Port Forwarding/Port Triggering page.
Change a port forwarding service
To edit a port forwarding entry:
1.
Launch a web browser from a computer or mobile device that is connected to your
mesh network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3.
Enter the router user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Port Forwarding/Port Triggering.
The Port Forwarding / Port Triggering page displays.
5.
Leave the Port Forwarding radio button selected as the service type.
6.
In the table, select the radio button next to the service name.
User Manual141Manage Port Forwarding and
Port Triggering
Nighthawk Tri-band Mesh WiFi 6E
To Next Page
Loading...
Need help?
General
