To sync the router and the satellite:
1.
Place the satellite in the same room as the router.
Use this satellite location only during the sync process.
2.
Connect the satellite to a power source.
3.
Press the Sync button on the router and then within two minutes, press the Sync
button on the satellite.
4.
Wait for the satellite LED to light.
The satellite LED blinks white while it attempts to sync with the router. After the LED
blinks white, it lights one of the following colors:
•
Blue. The router and satellite successfully synced, and the connection between
the router and satellite is good.
•
Amber. The router and satellite failed to sync. Try repeating Step 3 again. If the
sync keeps failing, try moving the satellite to a different location that's closer to
the router.
5.
Move the satellite to a new location and connect the satellite to a power source.
6.
At the new location, check the satellite LED and make sure it lights blue.
If the satellite LED lights blue, the satellite synced successfully. If the satellite LED
lights amber, move the satellite closer to the router and try again. The satellite must
be within range of the router's WiFi cover area for a good connection to the router.
Cannot log in to the router
Make sure that your computer or mobile device is connected to your mesh WiFi network.
If you do not want to use a WiFi connection, you can connect your computer to the
router with an Ethernet cable.
If you changed the admin password and you forgot what it is, see Reset the admin
password on page 108.
Cannot access the Internet
Check your network and Internet connections:
1.
Make sure that your WiFi-enabled computer or mobile device is connected to your
mesh network.
User Manual150Troubleshooting
Nighthawk Tri-band Mesh WiFi 6E
To Next Page
Loading...
Need help?
General
