Nighthawk AX8 8-Stream AX6000 WiFi Router
Manage Your Router 104 User Manual
2. Using a straightened paper clip, press and hold the Reset button for at least five seconds.
3. Release the Reset button.
The Power LED starts blinking. When the reset is complete, the router restarts. This process
takes about two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, if you are connected to the router web interface, do not close the browser, click a
link, or load a new page. Do not turn off the router. Wait until the router finishes restarting.
Erase the Settings
CAUTION: This process erases all settings that you configured in the router.
To erase the settings:
1. Launch a web browser from a computer or mobile device that is connected to the router
network.
2. Enter the router user name and password.
The user name is admin. The password is the one that you specified the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
3. Select ADVANCED > Administration > Backup Settings. The Backup Settings page displays.
4. Click the Erase button.
The configuration is reset to factory default settings. When the reset is complete, the router
restarts. This process takes about two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, do not close the browser, click a link, or load a new page. Do not turn off the router.
Wait until the router finishes restarting.
To Next Page
Loading...
Need help?
General
