Nighthawk AX8 8-Stream AX6000 WiFi Router
UseVPNtoAccessYourNetwork 135 User Manual
6. Click the Apply button.
Your settings are saved.
7. Click the ForWindows or ForNonWindows button and download the configuration files for
your VPN clients.
8. Unzip the configuration files and copy them to the folder where the VPN client is installed on
your device.
For a client device with Windows 64-bit system, the VPN client is installed at C:\Program
files\OpenVPN\config\ by default.
Block VPN Client Internet Access in the Router
By default, the router is set up to allow VPN connections only to your home network, not to the
Internet service for your home network. If you changed this setting to allow Internet access, you
can change it back.
To allow VPN clients to access only your home network:
1. Launch a web browser from a computer or mobile device that is connected to the router
network.
2. Enter the router user name and password.
The user name is admin. The password is the one that you specified the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
3. Select ADVANCED > Advanced Setup > VPN Service. The VNP page displays.
4. Select the Enable VPN Service radio button.
5. Scroll down to the Clients will use this VPN connection to access section, and select the Home
Network only radio button.
This is the default setting. The VPN connection is only to your home network, not to the
Internet service for your home network.
6. Click the Apply button.
Your settings are saved.
7. Click For Windows or For Non Windows button and download the configuration files for your
VPN clients.
8. Unzip the configuration files and copy them to the folder where the VPN client is installed on
your device.
To Next Page
Loading...
Need help?
General
