Use VLANS for Traffic Segmentation
40
ProSAFE 8-Port and 16-Port Gigabit Click Switch
The Switch Status screen displays.
6. Select VLAN.
The Basic Port-Based VLAN screen displays.
7. Select the Enable radio button.
A message displays asking if you want to delete previous VLAN settings.
8. Click the Yes button.
9. For each port to be added to the group, enter the ID of the VLAN group.
If all the VLAN groups share an uplink to the Internet or servers, enter all in the VLAN
Group field for the port that you want to use for the uplink.
10. Click the APPLY button.
Your settings are saved.
11. To create more VLANs, repeat these steps with another VLAN ID.
Use Browser-Based Access to Create a Basic Port-Based VLAN
To create a basic port-based VLAN:
1. Set up your computer to use an IP address in the same subnet as the IP address of the
switch.
2. Use an Ethernet cable to connect your computer to an Ethernet port on the switch.
3. Launch a web browser.
4. In the address field of the browser, enter the IP address of the switch.
You can find the IP address of the switch by using the ProSAFE Plus utility or get it from
the DHCP server. If the switch cannot get an IP address from a DHCP server, enter
192.168.0.239.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information screen displays.
6. Select VLAN.
The Basic Port-based VLAN Status screen displays.
To Next Page
Loading...
Need help?
General