Network Settings
24
ProSAFE 8-Port and 16-Port Gigabit Click Switch
6. Select System > Multicast.
7. Make sure that the IGMP Snooping Status Enable radio button is selected.
8. In the VLAN ID Enabled for IGMP Snooping field, type the name of the VLAN.
9. Click the APPL
Y button.
Your settings are saved.
Use Browser-Based Access to Specify a VLAN for IGMP
Snooping
To specify a VLAN for IGMP snooping:
1. Set up your computer to use an IP address in the same subnet as the IP address of the
switch.
2. Use an Ethernet cable to connect your computer to an Ethernet port on the switch.
3. Launch a web browser
.
4. In the address field of the browser
, enter the IP address of the switch.
You can find the IP address of the switch by using the ProSAFE Plus utility or get it from
the DHCP server
. If the switch cannot get an IP address from a DHCP server, enter
192.168.0.239.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information screen displays.
6. Select System > Multicast.
To Next Page
Loading...
Need help?
General