S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure Switching User Manual182
10. Click the Apply button.
Your settings are saved.
11. Click the Clear button to clear the statistics in the table.
12. Click the Refresh button to update the page to show the latest information.
The following table describes the nonconfigurable information displayed on the page.
Table 47. L2 Loop Protection Interface Information
Field Description
Loop Detected Shows whether a loop is detected on the interface. If the interface is disabled and then
reenabled, the status changes to No again.
Loop Count The number of packets that were received after the loop was detected.
Time Since Last Loop The time that elapsed since the loop was detected.
Port Status The status of the interface (Enabled, Disabled, or D-Disabled, which stands for
diagnostically disabled).
To Next Page
Loading...
Need help?
General