NETGEAR S350 Series User Manual

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Manage Device Security User Manual270
This field cannot be set if a redirect interface is already configured for the ACL rule. This
field is visible for a Permit action.
11. From the Redirect Interface menu, select the egress interface to which the matching traffic
stream must be redirected, bypassing any forwarding decision normally performed by the
switch.
This field cannot be set if a mirror interface is already configured for the ACL rule.
12. From the Match Every menu, select whether each Layer 2 MAC packet must be matched
against the rule:
• True. Each packet must match the selected ACL rule.
•
False. Not all packets need to match the selected ACL rule.
13. In the CoS
field, specify the 802.1p user priority that must be compared against the
information in an Ethernet frame.
The range for the priority is from 0 to 7.
14. In the Destination MAC field, specify the destination MAC address that must be compared
against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC address of 01:80:C2:xx:xx:xx.
15. In the Destination MAC Mask field, specify the destination MAC address mask that must
be compared against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC mask of 00:00:00:f
f:f
f:ff.
16. From the EtherType Key menu, select the EtherType value that must be compared against
the information in an Ethernet frame.
The values are as follows:
• Apple Talk
• IBM SNA
• IPv4
• IPv6
• IPX
• MPLS Multicast
• MPLS Unicast
• NetBios
• Novell
• PPPOE
• RARP
• User Value
17. If you select User V
alue
from the EtherType Key menu, in the EtherType User Value field,
specify the customized EtherType value that must be used.

NETGEAR S350 Series Specifications

General

Brand	NETGEAR
Model	S350 Series
Category	Switch
Language	English