S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure System Information User Manual66
6. From the Interface menu, select the interface.
7. From the Energy Detect Admin Mode menu, select Enable or
Disable.
By default, this mode is disabled for the port. When you enable this mode, and is the port
link goes down, the underlying physical layer goes down for a short period and then
checks for port link pulses again so that auto-negotiation remains possible. In this way,
the switch saves power when no link partner is present for the port. If Energy Detect
Admin Mode is not supported, N/A is displayed
8. From the EEE Admin
mode menu, select
Enable or Disable.
By default, this mode is disabled for the port. When you enable this mode, the port
transitions to low power mode during a link idle condition. If the EEE Admin Mode is not
supported, N/A is displayed.
9. In the EEE Transmit Idle Time
field, enter the time after which switch transitions to the LPI
state.
The range is 600 to 4294967295. The default value is 600.
10. In the EEE Transmit Wake T
ime field, enter the time that the switch must wait before it
transitions to the active state after it receives a packet for transmission.
The range is 8 to 65535. The default value is 17.
To Next Page
Loading...
Need help?
General