NETGEAR WG302 - 802.11g ProSafe Wireless Access Point - Page 109

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Command Line Reference C-3
July 2005 v3.0
[get set del keyword Description
--- --- --- ---------------------- -------------------------------
X] [X] [X] wlan --wireless setting
[X] |-version --wireless driver version
[X] [X] |-radio --enable wireless radio
[X] [X] |-wirelessmode --wireless mode
[X] [X] |-channel --wireless channel (depends on
country and wireless mode)
[X] [X] |-rate --wireless transmission date rate
[X] [X] |-ssid --wireless network name (1-32 chars)
[X] [X] |-ssidsuppress --wireless SSID broadcast suppress
[X] [X] |-power --wireless transmit power
[X] [X] |-antenna --wireless antenna selection
[X] [X] |-fragmentationthreshold--wireless fragmentation
threshold (even only)
[X] [X] |-rtsthreshold --wireless RTS/CTS threshold
[X] [X] |-beaconinterval --wireless beacon period in TU(1024
us)
[X] [X] |-dtim --wireless DTIM period in beacon
interval
[X] [X] |-preamble --wireless preamble (only effect on
802.11b
| rates)
[X] [X] |-super --enable wireless super-A/G mode
[X] [X] |-wirelessisolate --wireless isolate communication
between clients
[X] [X] |-operationmode --wireless operation mode
[X] [X] [X] |-remoteap --wireless remote AP(s) (depends on
operationmode)
[X] [X] [X] | |-p2p(+ap) --remote AP address for p2p mode
[X] [X] [X] | |-p2mp(+ap) --remote AP address for p2mp mode
[X] [X] [X] | | |-1 --1st remote AP address for p2mp mode
[X] [X] [X] | | |-2 --2nd remote AP address for p2mp mode
[X] [X] [X] | | |-3 --3rd remote AP address for p2mp mode
[X] [X] [X] | | `-4 --4th remote AP address for p2mp mode
[X] [X] [X] | `-repeater --remote AP address for repeater mode
[X] [X] [X] | |-1 --1st remote AP address for repeater
mode
[X] [X] [X] | |-2 --2nd remote AP address for repeater
mode
[X] [X] [X] | |-3 --3rd remote AP address for repeater
mode