- ENGLISH -
- 57 -
Example of report e-mail
“SERIAL” COMMUNICATION PORT SERVICES
NetMan plus can be configured via RS-232 by means of the “SERIAL” communication port; further
services are also implemented on the port, which can activated or deactivated according to
requirements (see paragraph “Configuration”). A brief description for each of these is given below.
Modem Tx/Rx
NetMan plus can be used to monitor the status of the UPS by means of a modem connected to the
“SERIAL” communication port.
If the “Modem Tx” service is activated, the modem can be enabled for transmission; the UPS is
thus able to make calls to a remote support station to notify any alarm situations. The device can
make calls to three different telephone numbers.
If the “Modem Rx” service is activated, the modem can be enabled to receive calls. This allows
monitoring of UPS status and operation from a remote support station or via the UPSMon software.
The “Modem Tx” service must be enabled.
To Next Page
Loading...