- ENGLISH -
- 58 -
RS-232 serial
The status of the UPS can be monitored via RS-232 by means of the “SERIAL” communication
port using, for example, UPSMon software. Communication is only active when the “Tx/Rx Modem”
service is disabled.
if the software requires a PRTK code and the UPS code is of the GPSER112… type,
the PRTK code to be used in the software is GPSER196…; that is, the seventh and
eighth characters of the code “…12…” must be replaced with the characters “…96…”,
remembering that the PRTK code must always consist of twelve characters
UPS VALUES AND EVENTS HISTORY LOG ARCHIVE
NetMan plus records the UPS values (Datalog) and events (Eventlog) in a history log archive. The
data are saved to file in text format and can be read either by means of an electronic spreadsheet
(which allows the data to be ordered chronologically) or by any text editor. The format used to
record the date and time is of the type: MM/DD/YY HH:MM:SS
Eventlog
The Eventlog service is always active and records all relevant UPS events in the ‘event.log’ file.
The file can be downloaded via FTP or sent by e-mail using the “Email report” service. The data
are saved in circular list mode, thus the most recent data are saved by overwriting the oldest data.
Example of Eventlog
To Next Page
Loading...