NetMan plus - Service Activation Menus; Activation of Network Services; Wake-on-LAN Service Configuration; Environmental Sensors Configuration

- ENGLISH -
- 78 -
Activation 1 menu
/------------------------/
/ Activation 1 /
/------------------------/
Enable telnet..:[ON/off]<-- Enable FTP.....:[ON/off]
Enable HTTP....:[ON/off] Enable DataLog.:[ON/off]
Enable Modem Tx:[on/OFF] Enable Modem Rx:[on/OFF]
Enable SNMP....:[ON/off] Enable Email...:[ON/off]
Enable UDP.....:[ON/off] Enable Report..:[ON/off]
With this menu the services implemented in NetMan plus can be activated or deactivated:
use the ENTER key to change the selected configuration (“ON” or “OFF”)
• ON (green characters): service active
• OFF (red characters): service not active
It is recommended to activate only the services used.
Services 2 menu
/------------------------/
/ Services 2 /
/------------------------/
WakeOnLan addr.:<--
WakeOnLan delay:
Activation.2...:
Sensors config :
I/O Sensors....:
With this menu the configuration screens of the various services can be accessed as described in
the following table.
Menù Funzione
WakeOnLan addr.
To configure the Wake-on-LAN service
WakeOnLan delay
Activation 2 To configure the services to be activated
Sensors. config
To configure the environmental sensors
I/O Sensors
as well as being configured, the services must also be activated to function correctly
(see paragraph “Activation 2 menu”). It is recommended to activate only the services
used.