- ENGLISH -
- 70 -
UPS config menu
/------------------------/
/ UPS config /
/------------------------/
PRTK Code......:GPSER11201XX
Name...........:ups3
UPS Address....:1
Serial number..:324321
With this menu the UPS parameters must be set as described in the following table, for the UPS to
be able to communicate correctly with the device.
Field Parameters to be inserted
PRTK Code Enter the PRTK code indicated at the back of the UPS
(1)
Name Enter the identifying name of the UPS
UPS Address Enter the UPS address for serial communication
(2)
Serial number Enter the UPS identification code for modem connection
(1)
The PRTK code is formed of 12 alphanumeric characters.
(2)
The address is only used when several UPSs are connected on a serial line.
After inserting the data and pressing the “ESC” key to exit from the menu, the settings can be
tested by pressing the “T” key. If the test is performed, a screen like the one shown below is
displayed, with some of the main UPS values. If the values remain at zero, this means that the
UPS and the device are not communicating correctly.
/------------------------/
/ Status /
/------------------------/
UPS On Input voltage..: 232V
On line
Load...........: 15%
Battery cap....: 100%
Autonomy.......: 75 min
To Next Page
Loading...