NetMan plus - Installation and Configuration; Jumper Settings Overview

- ENGLISH -
- 61 -
INSTALLATION AND CONFIGURATION
JUMPER SETTINGS
The jumpers on the card can be used to:
• activate or deactivate the autonegotiation of transmission speed and mode of the Ethernet
network (JP7, JP8, JP9)
• select 10/100Mbps or 10Mbps transmission speed (JP7, JP8, JP9)
• select half duplex or full duplex transmission mode (JP7, JP8, JP9)
• activate automatic netboot on start-up (JP14)
• enable the modem (JP10) or the environmental sensors (JP6, JP10)
Refer to the tables and figures below to configure the jumpers correctly.
NetMan 101 plus NetMan 102 plus
JP1
CLOSED NOT MOUNTED
JP2
JP3
NOT MOUNTED CLOSED
JP4
JP5
NOT MOUNTED
JP6
¾ OPEN = DISABLE ENVIRONMENTAL SENSORS
• CLOSED = ACTIVATE ENVIRONMENTAL SENSORS
JP10
¾ CLOSED 1-2 TO ENABLE THE MODEM
• CLOSED 2-3 TO ENABLE THE ENVIRONMENTAL SENSORS
JP11
NOT MOUNTED
JP14
¾ OPEN = AUTOMATIC NETBOOT INACTIVE
• CLOSED = AUTOMATIC NETBOOT ACTIVE
(1)
(1)
See paragraph “Firmware update”
NetMan plus
AUTO-NEG
SPEED
(Mbps)
DUPLEX JP7 JP8 JP9
Deactivated
10
Half PINS 2-3 closed PINS 2-3 closed PINS 2-3 closed
Full PINS 2-3 closed PINS 2-3 closed PINS 1-2 closed
10/100
Half PINS 2-3 closed PINS 1-2 closed PINS 2-3 closed
Full PINS 2-3 closed PINS 1-2 closed PINS 1-2 closed
Activated
only 100
Half PINS 1-2 closed PINS 2-3 closed PINS 2-3 closed
Full PINS 1-2 closed PINS 2-3 closed PINS 1-2 closed
10/100
only Half PINS 1-2 closed PINS 1-2 closed PINS 2-3 closed
Full or Half
¾ PINS 1-2
closed
¾ PINS 1-2
closed
¾ PINS 1-2
closed
the default configurations are shown with the symbol “ ¾ ”