- ENGLISH -
- 68 -
After pressing “ESC” and “Y” to confirm exit from the menu, a screen is displayed summarizing the
current settings (see image below). Press the “ENTER” key to return to the main menu. The
configuration must however be saved to make it effective after restart of the device (see “Save and
load” menu).
Hostname : ups_server.mynetwork.domain
Current IPv4 addr.: 10.1.10.187/16 (255.255.0.0) (active)
Current IPv6 addr.: fe80:0:0:0:260:35ff:fe02:4184/64 (active)
Default IPv4 GW : 10.1.4.1
Ethernet Address : 00:60:35:02:41:84
Primary DNS : 10.1.4.2
Secondary DNS : 10.3.4.1
DNS Timeout : 0 (ms)
DHCP Server : 10.1.5.1
DHCP Enabled : true
DHCP Lease Ends : Sun Jun 05 00:00:12 GMT 2005
(66 hr, 40 min, 38 seconds left)
Mailhost : mymailserver
Restore From Flash: Not Committed
Time setting menu
/------------------------/
/ Time setting /
/------------------------/
Set time.......:<--
Set timezone...:
Sync with NTP..:
From this menu the time and date of the device can be set as described in the following table.
Command Description
Set time To configure the time and date manually
Set timezone To configure the time zone
Sync with NTP To synchronize the clock with an NTP server
To Next Page
Loading...