NetMan plus - Page 69

- ENGLISH -
- 69 -
Pressing the “ENTER” key corresponding to the “Set time” command displays a screen like the one
shown below.
Current date is Wed Jun 15 08:09:40 GMT 2005
Insert new date and clock time in this form:
MMDDYYYYHHMMSS
06152005081000
Current date is Wed Jun 15 08:10:00 GMT 2005
Enter the date and time in the format shown, then press the ENTER key and then “ESC” to exit.
Pressing the “ENTER” key corresponding to the “Set timezone” command displays a screen like
the one shown below.
Current date is Thu Jun 16 12:15:25 GMT 2005
Available Timezones:
GMT (+0000) IET (-0500) CTT (+0800) VST (+0700) SST (+1100)
PST (-0800)* MST (-0700)* JST (+0900) AST (-0900)* EAT (+0300)
ECT (+0100)* NET (+0400) EET (+0200)* BET (-0300)* PLT (+0500)
PNT (-0700) IST (+0530) CST (-0600)* PRT (-0400) ACT (+0930)
MET (+0330)* ART (+0200)* AET (+1000)* AGT (-0300) MIT (-1100)
NST (+1200)* HST (-1000) CNT (-0330)* EST (-0500)* BST (+0600)
CAT (+0200)
* denotes a time zone that uses Daylight Savings
Insert new timezone:
ECT
Current date is Thu Jun 16 14:15:31 ECT 2005
Enter the time zone selected from those shown, then press the ENTER key and then “ESC” to exit.
Pressing the “ENTER” key corresponding to the “Sync with NTP” command displays a screen like
the one shown below.
Current date is Thu Jun 16 14:17:06 ECT 2005
Insert IP Address or host name of the NTP server to synchronize time:
leg
Synchronizing time to server: server.mycompany
New system time: 16 Jun 2005 12:17:00 GMT
Current date is Thu Jun 16 14:17:01 ECT 2005
Enter the name or the address of the NTP server with which the device is to be synchronized. In
this case the time has to be within the GMT time zone, thus it may be necessary to correct the
current time zone with the “Set timezone” command.