NBB-800
User Manual for NRSW version 4.5.0.100
5.7.2. DHCP Server
This section can be used to individually configure the Dynamic Host Configuration Protocol (DHCP)
service for each LAN interface which will serve dynamic IP addresses to hosts in the local network.
You may also have a look to the status page where you can find an overview about negotiated client
addresses.
Please note that WLAN interfaces (for each SSID) will pop up here as well in case you have configured
an access point respectively.
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
SDK
Administration
Job Management
Testing
DHCP Server
DNS Server
NTP Server
Dynamic DNS
E-mail
Events
SMS
SSH/Telnet Server
SNMP Agent
Web Server
Softflow
Discovery
Redundancy
Voice Gateway
DHCP Server Management
Network
Interface
Operation
Mode
DHCP Range Relay Server
Lease
Time
LAN1 Server
192.168.1.100
192.168.1.199
7200
LAN1-1 Server
192.168.101.100
192.168.101.199
7200
LAN1-2 Server
192.168.102.100
192.168.102.199
7200
WLAN1 Server
192.168.200.100
192.168.200.199
7200
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.39.: DHCP Server
The following settings for each interface can be applied then:
Parameter DHCP Server Settings
Operation mode Specifies whether the DHCP server is enabled or not
First lease address The first address out of the range of IP addresses given to hosts
Last lease address The last address out of this range
Lease duration Number of seconds how long a given lease shall be valid until it has
to be requested again
122
To Next Page
Loading...
