NetModule NB800 Series - Serial Port Settings

NBB-800
User Manual for NRSW version 4.5.0.100
Running a device server, the following settings can be applied:
Administration Port Settings
NetModule Router Simulator
Hostname NB1600
Software Version 4.4.0.103
© 2004-2020, NetModule AG
WAN
Link Management
Supervision
Settings
Ethernet
Port Setup
VLAN Management
IP Settings
Mobile
Modems
SIMs
Interfaces
WLAN
Administration
Configuration
IP Settings
Bridges
USB
Serial
Digital I/O
GNSS
SERIAL1 Port Settings
Physical protocol:
RS232
Baud rate:
115200
Data bits:
8 data bits
Parity:
None
Stop bits:
1 stop bit
Software flow control:
None
Hardware flow control:
None
Server Configuration
Protocol on IP port:
Telnet
Port:
2000
Timeout:
endless
numbered
600
Allow remote control (RFC 2217):
Show banner:
Allow clients from:
everywhere
specify
Apply
HOME INTERFACES ROUTING FIREWALL VPN SERVICES SYSTEM
LOGOUT
Figure 5.18.: Serial Port Settings
Parameter Serial Settings
Physical protocol Selects the desired physical protocol on the serial port
Baud rate Specifies the baud rate run on the serial port
Data bits Specifies the number of data bits contained in each frame
Parity Specifies the parity used for every frame that is transmitted or re-
ceived
Stop bits Specifies the number of stop bits used to indicate the end of a frame
69