NBB-800
User Manual for NRSW version 4.5.0.100
5.3.5. Software Bridges
Software bridges can be used to bridge layer-2 devices like OpenVPN TAP, GRE or WLAN interfaces
without the need for a physical LAN interface.
Bridge Settings
This page can be used to enable/disable software bridges.
It can be configured as follows:
Parameter Bridge Settings
Administrative status Enables or disables the bridge interface. If you need an interface to
the local system you need to define an IP address for the local device.
IP Address IP address of the local interface (available only if "Enabled with local
interface" was selected
Netmask Netmask of the local interface (available only if "Enabled with local
interface" was selected
MTU Optional MTU size for the local interface (available only if "Enabled
with local interface" was selected
63
To Next Page
Loading...
