NBB-800
User Manual for NRSW version 4.5.0.100
Parameter Install
Install If this trigger is set the image download will start on apply. Any existing
root file system will be overwritten. This parameter will not be stored
in the configuration. After the installation was proceeded the value will
be reset and needs to be set again if a new image shall be installed.
Communication to and from the guest can be achieved by defining network interfaces which can be
either routed towards the guest or bridged with a LAN interface:
Parameter Guest Networking
Guest interface The name of the interface inside the guest
Mode The network mode for this interface (either routed or bridged)
Address The IP address of the interface inside the guest
Netmask The netmask of the interface inside the guest
Gateway The gateway used inside the guest which is also set on the host inter-
face
Bridge interface The interface to which the guest interace shall be bridged
The guest devices parameter shows a list of devices (e.g bluetooth, CAN) which can be provided to
the guest system.
Parameter Guest Devices
Enable devices Enable or disable device for the guest
In order to limit the ressources for a guest, the following settings can be applied:
Parameter Guest Limits
CPU The number of CPUs used for the guest
Memory The amount of memory available for the guest
Reboot
This page can be used to set up a periodic automatic reboot but also to trigger a manual reboot which
will be issued immediately.
166
To Next Page
Loading...
