NBB-800
User Manual for NRSW version 4.5.0.100
Configurable parameters for access-point, client mode, mesh point and any dual mode:
Parameter WLAN Management
Regulatory Domain Select the country the Router operates in
Number of antennas Set the number of connected antennas
Antenna gain Specify the antenna gain for the connected antennas. Please refer to
the antennas datasheet for the correct gain value.
Disable low data rates Avoid sticky clients by disabling low data rates.
Warning
Please be aware that any inappropriate parameters can lead to an infringement of con-
formity regulations.
Running as access point or dual mode, you can further configure the following settings:
Parameter WLAN Management
Operation type Specifies the desired IEEE 802.11 operation mode
Radio band Selects the radio band to be used for connections, depending on your
module it could be 2.4 or 5 GHz
Bandwidth Specify the channel bandwidth operation mode
Channel Specifies the channel to be used
Short Guard Interval Enables the Short Guard Interval (SGI)
Running as client, you can further configure the following settings:
Parameter WLAN Management
Scan channels Select if all supported channels should be scanned or just user de-
fined channels
2.4 GHz Set the channels which should be scanned in 2.4 GHz
5 GHz Set the channels which should be scanned in 5 GHz
Available operation modes are:
Standard Frequencies Bandwidth Data Rate
802.11a 5 GHz 20 MHz 54 Mbit/s
802.11b 2.4 GHz 20 MHz 11 Mbit/s
53
To Next Page
Loading...
