NBB-800
User Manual for NRSW version 4.5.0.100
This section can be used to configure security-related settings.
Parameter WLAN Access-Point Configuration
SSID The network name (called SSID)
Security mode The desired security mode
WPA/WPA2 mixed mode WPA2 should be preferred over WPA1, running WPA/WPA2 mixed-
mode offers both.
WPA cipher The WPA cipher to be used, the default is to run both (TKIP and
CCMP)
Identity The identity used for WPA-RADIUS and WPA-EAP-TLS
Passphrase The passphrase used for authentication with WPA-PSK, otherwise the
key passphrase for WPA-EAP-TLS
Force PMF Enables Protected Management Frames
Hide SSID Hides the SSID
Isolate clients Disables client-to-client communication
Band steering master The WLAN interface which the client should be steered to
Accounting Sets accounting profile
The following security modes can be configured:
Parameter WLAN Security Modes
Off SSID is disabled
None No authentication, provides an open network
WEP WEP (is nowadays discouraged)
WPA-PSK WPA-PSK (TKIP, CCMP) aka WPA-Personal/Enterprise, provides
password-based authentication
WPA-RADIUS EAP-PEAP/MSCHAPv2, can be used to authenticate against a re-
mote RADIUS server which can be configured in chapter 5.8.2
WPA-TLS EAP-TLS, performs authentication using certificates which can be
configured in chapter 5.8.8
58
To Next Page
Loading...
