NBB-800
User Manual for NRSW version 4.5.0.100
When running the serial port as AT modem emulator the following settings can be applied:
Parameter Serial Port Settings
Physical protocol Selects the desired physical protocol on the serial port
Baud rate Specifies the baud rate run on the serial port
Hardware flow control You may enable RTS/CTS hardware flow control, so that the RTS and
CTS lines are used to control the flow of data
Parameter Incoming connections via Telnet
Port The TCP port for the device server
Parameter Phonebook Entries
Number Phone number that will get an alias
IP address IP address the number will become
Port Port value for the IP address
71
To Next Page
Loading...
