Place the platter on the scale platform and then connect
. The AC cord (power cord) goes
side of the scale; there is a label on
the scale by the connector ports which indicates
each connector is for.
5.
Make sure that the power switch is in the OFF position
which is located above the AC cord connector.
6. Plug the scale into an AC source. Note:
must be 85V ~ 240V DC 50/60 Hz +2%.
7. Turn
the power switch to the ON position. The scale will
do the display test and then go to zero.
8. Press the
key 2 or 3 times collecting the labels as
they are fed out each time you press the key.
9. The scale should be in the Initial State; all the displa
should read:
This is the Initial State
. Most directions and instructions in this manual
will begin with setting the scale up to the Initial State. Pl
familiarize yourself with how to get the scale to the Initial State
state is achieved by simply turning the scale on.
To Next Page
Loading...
General