91
PC to Scale Data Transfer
You can use your PC to store data files for the NETS scale, all you
need to do is to purchase the NETS Software Package. Contact your
local ACOM Dealer for purchasing options. This is NOT a network
function nor can it become one. PC to scale data transfer uses
serial (RS-232) communication to transfer data, which can only be
wired from 1 PC to 1 scale. For Ethernet TCP/IP networking
availability, please contact dealer:
To transfer data from PC-to-Scale:
1. Place the PC and the scale together.
2. Make sure that the Power Switch is off on both the PC and the
NETS .
3. Connect the PC-to-Scale cable: the female side goes to the PC and
the male side goes to the NETS .
4. Turn the PC on, then turn the scale on, and wait for the scale to go
to the Initial State.
5. Follow the instructions that accompanied your NETS Software
Package.
Note
1
: You can have multiple scales. The master scale manages
the slave sale. If the master scale is connected with pc, the master
scale automatically sends and saves the received data from pc. But
between The slave scale and slave scale can not transmit.
To Next Page
Loading...
General