Nets NETS - Label Settings; Label; Receipt Mode

57
You can choose one of them Y(1): Yes, or N(0): No.
7. Label Settings
7-1. Label / Receipt
You can choose the print mode. If you set
1
Label mode, the gap
sensor and the peel off sensor will perform. If you set
2
Receipt
mode, the gap sensor and the peel off sensor will not perform.
And the receipt is printed by operator in sub total view.
Enter ‘Main menu’, and follow 2 steps below.
1. Press
7
-
1
.
2. Press
1
for “Label” or
2
for “Receipt”. The default
setting is “1”.
3. Press
PRINT
ESC
SET
to save the setting and return to the
Initial State.
7-2 Label option
To set Label Length:
1. Enter ‘Main menu’, and follow 3 steps below.
2.Press
7
-
2
-
1
.