20
Password
When you purchase the
NETS, it comes with password protection by
default. The initial password is “77559”; 5 digits
passwords or change the password. If your scale has password
protection enabled, then you can change the password by following the
instructions in the General Programming section under
our scale has password protection disabled or you wish to
disable password protection, you must contact your ACOM
Changing this feature is only permitted by
licensed individuals.
There are only two places where the NETS wil
entry screen: 1 to enter the Main Menu and 2
from Sales Mode (Initial State
This is your cue to enter the password; of course, if passwords are
en this screen will always be skipped. For a new scale, you
proceed to the next screen.(The scale manager must use [1111].
However, this number possibly to be changed.)
Passwords are composed of the numbers 0 to 9.
password, the Total Price display will display a dash for every number
that you press. When you are done entering your password, press
. If you entered the correct password you will go on to the next
screen; if not, you will remain at the password entry screen.
If you wish to exit the password entry screen, press
will go back to Sales mode. Do not forget your password; write it down
somewhere safe. If you forget your password, you will NOT be able to
the scale; the only way to correct this problem is to call your
Dealer who may have to clear out ALL of the scale’s memory
and completely reprogram the scale, which may or may not incur
additional charges. Note: if you wish not to use passwords, hav
ACOM Dealer set your scale up accordingly.
To Next Page
Loading...
General