Silent Setting
The alarm system may be full or part-set such that the internal sounders are switched off during
the exit procedure. However the system will give a short tone at the end of the exit procedure to
indicate that the system has successfully set.
»
To full set the alarm system silently, proceed as fo llows:
1. Enter your passcode ? ? ? ?. The
display will show:
2. Within 5 seconds press 8. The display
will show:
3. Leave via the prescribed exit route.
4. The system is full set when the exit time
has expired, on activation of the Final Exit
circuit or by pressing the Exit Terminator
button, as appropriate.
» To part-set the alar m system silently, p roceed as follows:
1. Enter your passcode ? ? ? ?. The
display will show:
2. Within 5 seconds press the required
part-set button A, B or C, e.g., press “A”
for part-set A then press 8. The display will
show:
3. Leave the area or premises via the
prescribed exit route.
4. The system is part-set when the exit time
has expired, on activation of the Final Exit
circuit or by pressing the Exit Terminator
button, as appropriate.
10
Operating The System TS790 & TS90 0 User Manual
Press ENT to
Select Functions
LCD
FUNCTION
Starburst
Func
.
LED
Please Exit Now.
Time left > 9999
9999
9999
Press ENT to
Select Function
LCD
FUNCTION
Starburst
Func
.
LED
Setting the
Office Area Only
P. SET A
PS.A
To Next Page
Loading...
