Networker TS900 - Code Set Groups - [3.3]

Cod e Set Group s - [3.3]
This option allows the user passcode types “Code Set Group A”, “Code Set Group B”, “Code Set
Group C” and “Full Set Group” to be defined so that each may Set or Unset any combination of
Wards (A, B and C) and the System Ward. e.g., “Code Set Group A” may be defined to Set and
Unset Wards A and B only and “Code Set Group B” defined to Set and Unset Wards B, C and the
system etc.
1. Ensure that “User menu 3" is selected.
Press 3 to select the Code Set Groups
option. The display will show:
2. Select the Code set group by pressing:
A To select “Code set Group A”
B To select “Code set Group B”
C To select “Code set Group C”
0 To select “Full set Group”
e.g., To select “Code set Group A”,
press “A”. The display will show:
3. Select/de-select the wards by pressing:
0 To select/de-select “Ward S”
A To select/de-select “Ward A”
B To select/de-select “Ward B”
C To select/de-select “Ward C”
e.g., to add “Ward C”, press “C”. The
display will show:
4. When the display shows the required
setting press [ to accept. The display will
return to step 1, repeat for the other “Code
set Groups” or press ] to return to “User
menu 3".
Code Set Group Operation
When the system is unset and a “Code set Group” passcode is entered the selected areas
(wards) will set after the setting procedure is followed. e.g., If “Code set Group A” is defined as
above then when the passcode is entered it will set wards A and C. If the system is fully set and
the passcode is entered it will unset wards A and C.
The“Code set Group”passcodes are programmed by the master user within “Usermenu 2" (see
page 25).
40
User Menu 3 TS790 & TS90 0 User Manual
Code set Group ?
Enter Group >-
LCD
C.S GRP-
Starburst
CSG
.
-
LED
Code set Group A
Will set [ A ]
A
A
Code set Group A
Will set [ A C]
A C
A C