Operating The System
Introduction
Initial access to the system is gained by entering a 4 digit passcode. Every time you wish to use
the system your passcode must be entered correctly. If a passcode is repeatedly entered
incorrectly a code tamper alarm will be generated.
Up to 31 separate user passcodes are available for operating the system. The master user (user
01) is the person responsible for allocating other users to the system.
Each user (02-31) may be defined for different authorisation levels. See page 25 for full details,
the table below shows the code levels and their menu access:
Code level User Menu 1 User Menu 2 User Menu 3
Master
4
4 * 4 *
Standard
4
Holiday
4
Set Only
4
Reset Only Options 1-9 only
PA Code
4
Access Used for access control
Full Set Group Only allows setting and unsetting of selected wards
Code Set Group A
Code Set Group B
Code Set Group C
*Iftheinstallationcompanyhasprogrammedthemasteruserforlimitedaccess,heorshewillNOThaveaccessto
“User menu 2" options 6 and 8, and all options in ”User menu 3".
U ser Menus
In general when ever a user passcode is entered the system will enter into a 5 second function
mode,ifthe [ button ispressedduringthistime “Usermenu1"isselected,asareminder,abrief
description ofeach menuoption within ”Usermenu1“isprinted underneatheachbutton on the
the remote keypads, e.g., button 1 selects the ”Bell Test" option. If the [ button is not pressed
within 5 seconds the system will attempt to full set.
Whenanyofthe menuoptions are selected theusermayabandon thefunctionbypressing the
] button. If the ] button is repeatedly pressed whilst one of the user menus is selected, the
alarm system will return to the normal “OPEN” condition.
Engineer on Site Message
When the installation engineer attends the site for routine maintenance etc. the remote
keypads may show “Engineer on site” (ENG ON SITE), whilst this message is displayed the
alarm system remains fully operational. However, before the engineer leaves the site he should
ask one of the users to enter their passcode followed by ], this will clear the "Engineer on site”
message and return the system to the normal “OPEN” condition.
4
Operating The System TS790/ TS900 User Manual
To Next Page
Loading...
