Networker TS900 - Unsetting after an Alarm; Resetting after an Alarm; User Reset

U nsett ing After An Alarm
If an alarm has occurred whilst the alarm system is full or part-set, the display will indicate the
detection circuit that was triggered when the system is unset. Once the cause of the alarm has
been established the system must be reset (see “Resetting after an alarm”).
1. Enter the premises or area via the
prescribed entryrouteandproceed directly
totheremotekeypad.Theinternalsounders
will generate an interrupted tone. The
display will show how much time you have
left, e.g.,
2. Enter your passcode ? ? ? ? within
theentrytime. The internalsounderswill stop
and the display will show the detection
circuit that caused the alarm, e.g.,
3. Refer to “Resetting a fter an Alarm”
+
If “Circuit Text” hasbeen programmed then the display on the LCD and Starburst remote
keypads will alternate between the “Circuit number” and the “Circuit Text” at step (2).
R esetting Aft er An Alarm
The installation company will have programmed the system to be either “User Reset”, “Engineer
Reset” or “Remote Reset”, consult your installation company if you are not sure.
User Reset
From step (3) of “Unsetting After An Alarm” proceed follows:
1. Enter your passcode ? ? ? ?. The
display will show:
2. Within 5 seconds press ]. The display
will show:
3. After 5 seconds the “SYSTEM OPEN”
message will disappear and the display will
show the time, (date and banner text, LCD
only) e.g.,
Your alarm system is reset by: User: o Engineer: o Remote Reset: o
(Continued Over)
11
TS790 & TS90 0 User Manual Operating The System
ALARM 03
09:45.59 28/04
ALARM 03
CA
.
03
Enter Your Code
Time left > 0025
LCD
0025
Starburst
0025
LED
Office Detector
09:45.59 28/04
OFFICE
Press ENT to
Select Functions
LCD
FUNCTION
Starburst
Func
.
LED
SYSTEM OPEN
08:30 Sun 28 APR
OPEN
OPEN
ABC Security
08:30 Sun 28 APR
08.30
08
.
30