R emote Reset - [1.3]
This option allows the user to Reset the system after an alarm by using a "Remote Reset" code.
The full procedure is explained in "Resetting After an Alarm" on page 12.
Change Pas scode - [1.4]
Thisoptionallows allusers that have accessto "Usermenu 1"to change their ownpasscode.The
master users can also add and delete user passcodes, see "Setup Users" on page 25.
1. Ensure that "User menu 1" is selected.
Press 4 to select the Change Passcode
option. The display will show:
2. Enter your new passcode (e.g., 1212)
the display will show:
3. Press[ toacceptthenewpasscode,a
multi-tone indicates that the new passcode
has been accepted and the display will
automatically return to "User menu 1". A low
tone indicates that the passcode is not
available. Repeat again from (1) trying a
different four digit number.
Enable Chime - [1.5]
Detection circuits that have been programmed as "Chime" by the installation company or the
master user will generate a two-tone sound if activated. This menu option allows the user to
select one of the five "Chime" options:
Disabled
-
All detection circuits programmed as “Chime” will not generate a
“Chime” tone when activated.
Ena bled
-
Alldetectioncircuitsprogrammed as “Chime”will generate a“Chime”
tone when activated.
Ena bled in P.Set
-
Alldetectioncircuitsprogrammed as “Chime”will generate a“Chime”
tone when activated during the part-set condition.
Ena bled in Unset
-
Alldetectioncircuitsprogrammed as “Chime”will generate a“Chime”
tone when activated during the unset condition.
Ena bled o/p A On
-
Alldetectioncircuitsprogrammed as “Chime”will generate a“Chime”
tone only when “Custom O/P A” is active. "Custom O/P A" is configured
by the installation company and may be programmed to go active
only when certain condition are true, e.g., the output could be
programmed to follow one of the "Time Switch" outputs thus allowing
the chime to be enabled during a time window.
(continued over)
19
TS790 & TS90 0 User Manual User Menu 1
Change pass code
New code > 1212
1212
1212
-- --
Starburst
----
LED
Change pass code
New code > ----
LCD
To Next Page
Loading...
