Networker TS900 - Unsetting Individual Wards with Standard User Passcodes

U nsett ing individual Wards with Standard User Passcode s
Ifthe installation company hasconfiguredthe alarm system asdescribed onthe previous page
the standard and master users will be given access to the “Ward Selection Menu” when
unsetting the alarm system.
»
The following example shows how to unset wards A and B.
1. Enter the premises via the prescribed
entry route and proceed directly to the
remote keypad. The internal sounders
generate an interrupted tone. The display
will show the remaining entry time:
2. Enteryour passcode? ? ? ? before
theentrytimerexpires.Thedisplaywillshow:
3. Deselect the wards by pressing:
A for “Ward A”
B for “Ward B”
C for “Ward C”
0 for “Ward S”
e.g., to unset wards A and B, deselect
wards S and C. The display will show:
4. When the display shows the required
wards, press [. The entry sounder will stop
and the display will show the wards that are
set:
»
To unset further wards (assuming wards S and C are set)
1. To unset another ward enter your
passcode ? ? ? ?. The display will
show:
2. Select the ward(s) you require to unset,
e.g., to unset ward C, deselect ward S. The
display will show:
3. When the display shows the required
ward(s) press [. The display will show the
wards that are set:
14
Operating The System TS790 & TS90 0 User Manual
Please Confirm
Unset -: S A B C
SABC
SABC
Please Confirm
Unset -: * A B *
-AB-
-AB-
Wards set [S C]
05:40 Sun 28 APR
PART SET
P
.
SET
S-- C
S--C
05.40
05
.
40
Please Confirm
Unset -: S * * C
S-- C
S--C
Please Confirm
Unset -: * * * C
-- -C
---C
Wards set [S ]
05:50 Sun 28 APR
PART SET
P
.
SET
S
S
05.50
05
.
50
Enter Your Code
Time left > 0025
LCD
0025
Starburst
0025
LED