1. Ensure that "User menu 1" is selected.
Press 7 to select the Omit Circuits option.
The display will show:
2. Select the circuit by entering its number
or by pressing:
A To scroll up one circuit
C To scroll down one circuit
e.g., for circuit 03 enter "03". The top
line of the display will show the circuit
text (if programmed) and the bottom
line shows whether the circuit is "Armed"
or "Omitted" e.g.:
3. Press B to toggle between "Armed" or
"Omitted". If a low tone is generated when
pressing "B"then the selected circuit cannot
be omitted.
4. When the display shows the required
setting, press [ to accept. The display will
show the next circuit:
5. If required repeat from step (2) for other
circuits. When finished press ]. If 24hr or
Auxiliary circuits were selected the system
will return to the unset condition and the
display will show:
6. If Nightcircuits were selected the system
will return to the "User menu 1" and the
display will show:
7. The system can now be full or part-set
with the selected Night circuits omitted by
pressing:
0 for full set
A for part-set A
B for part-set B
C for part-set C
e.g., To full set the system, press "0" and
leave via the prescribed exit route. The
display will show:
+
If Night circuits have been selected as omitted, the alarm system MUST be set or part-set
from "User menu 1" in order to invoke the omitted circuits.
21
TS790 & TS90 0 User Manual User Menu 1
CCT01-A
Starburst
O1-A
LED
Omit Circuits
Enter CCT No.>--
LCD
CCT03-A
O3-A
Office Detector
CCT 03 Armed
CCT03-O
O3-O
Office Detector
CCT 03 Omitted
CIRCUITS
CCTS
CCTS ISOLATED
08:30 Sun 28 APR
OMITTED
ISOL
USER 1-
1 -
User menu 1
Select Option :-
9999
9999
Please Exit Now.
Time left > 9999
CCT04-A
O4-A
Store Room PIR
CCT 04 Armed
To Next Page
Loading...
