INSTRUMENTATION & CONTROLS
60 Copyright © 1998 New Flyer Industries Ltd.
Hill Holder Switch
This switch is a guarded momentary switch that operates the
brakes. Moving the switch applies the brakes. Release the switch
when the propulsion system torque can move the vehicle in the
desired direction. Its use prevents unexpected motion when start-
ing on a hill.
Hazard Lights Switch
The Hazard Lights toggle switch controls the vehicle’s four-way
flashing lights. Positioning the switch to ON, flashes the exterior
signal lights and the turn indicators on the dash. Positioning the
switch to OFF, returns the exterior signal lights to the turn signal
function. Activate the hazard lights when stopping or parking the
vehicle in an area that may block traffic or present a possible haz-
ard to following or approaching vehicles. Also use the hazard
lights when towing the vehicle.
Door Controller
WARNING:
If the Door Master switch is in the OFF position, the
interlocks and the door controller are disabled.
The door controller opens and closes the passenger doors. The
five positions of the controller and their related door functions are
as follows:
• Position #1: Entrance door closed, rear doors closed.
• Position #2: Entrance door open, rear doors closed.
• Position #3: Entrance door open, rear doors open.
• Position #4: Entrance door closed, rear doors open.
• Position #5: Entrance door open, rear doors open.
Placing the door controller in positions 3, 4, or 5 applies the
interlocks and illuminates the Rear Door Open indicator on the
instrument panel.
To Next Page
