Newport Electronics INFINITY Series - 5 Display Messages; Table 5-1. Display Messages

5
Display Messages
SECTION 5. DISPLAY MESSAGES
Table 5-1. Display Messages
MESSAGE DESCRIPTION
RTD RTD Meter
RST Hard (power on) reset
INPT Input type
DEC.P Decimal point
ER2 One or more the following items have overflowed because of decimal
point change: setpoint values, setpoint deadbands, proportional bands
or manual reset.
RD.CF Reading configuration
COLR Display color
S1.CF Setpoint 1 configuration
S2.CF Setpoint 2 configuration
S1.DB Setpoint 1 deadband
S2.DB Setpoint 2 deadband
OT.CF Output Configuration
P.BND Proportional band
M.RST Manual reset
ER4 Manual reset error
OT.S.O Output scale and offset
T.OFF RTD temperature offset
ER3 RTD temperature offset limit
LK.CF Lock out configuration
+OL + Overload signal
-OL - Overload signal
TUNE Tuning proportional controller
OPN Sensor breaker or temperature outside the range
bRit Display brightness
+999 Value overflow in setpoint/menu peak deviation routines
-1999 Value overflow in setpoint/menu peak deviation routine
ER1 2 coordinate format programming error
PEAK Peak value
PK.RS Peak reset
SP.RS Reset setpoints
TUNE Tuning proportional controller
SP1 Setpoint 1 value
SP2 Setpoint 2 value
v.-
8.8
Firmware version (where
8
is 0~9)
32