Modem
Reference Manual for EL470 IP Satellite Modem
Command
DmExcBWStat
Actual roll-off factor Actual roll-off fact
Location /Modem/Monitor/Demodulation
Description
Readout of the actual used roll-off factor in cases when the automatic roll-
off detection is used.
RMCP
Command
Rfr Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01DemodulatorEntry
Command ntcDevsMod01DmExcBWStat
OID 1.3.6.1.4.1.5835.3.1.13.1.9.1.1
Values Factory Default
x25RCRO
Enumeration Value
35%
25%
20%
1
2
3
Command
DmAftDecBER
Bit error ratio after RS Bit err. ratio after
Location /Modem/Monitor/Demodulation
Description
Readout of the estimated bit error rate of the output data. This figure is
calculated from the pre-Reed-Solomon decoder byte error rate.
RMCP
Command
Rub Access Normal user : no
access
Expert user : R
SNMP Table ntcDevsMod01DemodulatorEntry
Command ntcDevsMod01DmAftDecBER
OID 1.3.6.1.4.1.5835.3.1.13.1.4.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA
Expert Range (CU)
0 .. 1
Command
DmPilots
DVB-S2 Physical Layer
Pilots
Pilots
Location /Modem/Control/Demodulation
Description
Configuration of the DVB-S2 physical layer pilot detection. The following
options are possible:
• Auto : Auto detection of the presence of pilots.
• On : Pilots are present in the received signal.
• Off : Pilots are not present in the received signal.Remark: This is a
constant coding and modulation command.
RMCP
Command
ACp Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01DemodulatorEntry
Command ntcDevsMod01DmPilots
OID 1.3.6.1.4.1.5835.3.1.13.1.52.1.1
Values Factory Default Enumeration Value
version 3.1
103
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
