Newtec EL470 - Page 114

Modem Reference Manual for EL470 IP Satellite Modem
Command
DmExcBW
Roll-off factor Roll-off factor
20% 3
Command
DmPidFilteringControl
PID filtering PID filtering
Location /Modem/Control/Demodulation
Description
Enable or disable PID filtering.
RMCP
Command
dpf Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01DemodulatorEntry
Command ntcDevsMod01DmPidFilteringControl
OID 1.3.6.1.4.1.5835.3.1.13.1.149.1.1
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
/Modem/Control/Demodulation/Backup carrier
Command
DmBuRxRfFreq
Backup receive
frequency
Backup receive frequ
Location /Modem/Control/Demodulation/Backup carrier
Description
Controls the RF input frequency for the backup carrier configuration.
RMCP
Command
BRF
array : [1 ..
2]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01DemodulatorExtEntry
Command ntcDevsMod01DmBuRxRfFreq
OID 1.3.6.1.4.1.5835.3.1.13000.1.17.1.1.[1 .. 2]
Values GUI Unit
MHz
Cmd Unit Factory Default (CU)
Hz 1.170000
Expert Range (CU)
950000000 ..
2150000000
Command
DmBuSynRate
Backup symbol rate Backup symbol rate %
Location /Modem/Control/Demodulation/Backup carrier
Description
Backup nominal symbol rate, used when we fail to lock on the primary
demodulator parameters.
RMCP
Command
BSR
array : [1 ..
2]
Access Normal user : RW
Expert user : RW
version 3.1
107
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS