Newtec EL470 - Page 127

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthStatsReset
Reset Ethernet
Counters
Reset Ethernet Count
Values Factory Default
never
Enumeration Value
Each period (5 s)
Never
Once
0
1
2
Command
IfGbeConfigError
Last config error Last config error
Location /Modem/Monitor/Interfaces/Ethernet
Applicable for the whole unit and not only for the Ethernet interface.
Description
Readout of the error string describing the last configuration error.
RMCP
Command
GCE Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfGbeConfigError
OID 1.3.6.1.4.1.5835.3.1.4.1.193.1.1
Values Factory Default String Description
length : 0 .. 120
format : any chars
Command
IfGbeSwError
Last software error Last software error
Location /Modem/Monitor/Interfaces/Ethernet
Applicable for the whole unit and not only for the Ethernet interface.
Description
Readout of the most recent software error message (if any). A fatal error
message survives a soft reset. This message is fully cleared after a hard
reset.
RMCP
Command
sem Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfGbeSwError
OID 1.3.6.1.4.1.5835.3.1.4.1.214.1.1
Values Factory Default String Description
length : 0 .. 130
format : any chars
version 3.1
120
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS