Newtec EL470 - Page 128

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfGbeSwErrCount
#Software errors #Software errors
Location /Modem/Monitor/Interfaces/Ethernet
Applicable for the whole unit and not only for the Ethernet interface.
Description
Readout of the number of software errors encountered on this system. A
fatal error inside the counter survives a soft reset. The counter is fully
cleared when a hard reset occurs.
RMCP
Command
sec Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfGbeSwErrCount
OID 1.3.6.1.4.1.5835.3.1.4.1.213.1.1
Values GUI Unit
errors
Cmd Unit Factory Default (CU)
errors 0
Expert Range (CU)
0 .. 4294967295
Structured Command
IfBBCounters
Baseband Counters Baseband Counters
Location /Modem/Monitor/Interfaces/Ethernet
Only valid for DVB-S2 modes.
Description
Readout of the baseband counters: transmit counters, receive counters
and drop counters.
RMCP
Command
IBc Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfBBCounters
OID 1.3.6.1.4.1.5835.3.1.4.1.57.1.1
Variables
IfBBTXCounter
IfBBTXBBFCounter
IfBBRXCounter
IfBBRXBBFCounter
IfBBRXDropCounter
IfBBRXTSCrcErr
IfBBRXBBFCrcErr
Page
198
198
198
198
199
199
199
version 3.1
121
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS