Newtec EL470 - Page 131

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfBBTXEstimOutpRate
BB TX Estim output
rate
BB TX Estim output r
bps bps 0 0 .. 4294967295
Command
IfBBTXDvbs2FillingLevel
BB TX DVB-S2 filling
level
BB TX DVB-S2 filling
Location /Modem/Monitor/Interfaces/Ethernet
Only valid for DVB-S2 modes.
Description
This is the average percentage of valid data that is present in the DVB-S2
baseband frames. The remaining bytes are padded.
RMCP
Command
bfl Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfBBTXDvbs2FillingLevel
OID 1.3.6.1.4.1.5835.3.1.4.1.175.1.1
Values GUI Unit
%
Cmd Unit Factory Default (CU)
% 0
Expert Range (CU)
-1e+38 .. 1e+38
Command
IfBBRXEstimBitRate
BB RX Estim raw
bitrate
BB RX Estim raw bitr
Location /Modem/Monitor/Interfaces/Ethernet
Description
Readout of the estimated bitrate received from the demodulator.
RMCP
Command
Brb Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfBBRXEstimBitRate
OID 1.3.6.1.4.1.5835.3.1.4.1.173.1.1
Values GUI Unit
bps
Cmd Unit Factory Default (CU)
bps 0
Expert Range (CU)
0 .. 4294967295
Command
IfBBRXEstimFrameRate
BB RX Estim raw
framerate
BB RX Estim raw fram
Location /Modem/Monitor/Interfaces/Ethernet
Description
Readout of the estimated framerate received from the demodulator.
RMCP
Command
Brf Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfBBRXEstimFrameRate
OID 1.3.6.1.4.1.5835.3.1.4.1.174.1.1
Values GUI Unit
fps
Cmd Unit Factory Default (CU)
fps 0
Expert Range (CU)
0 .. 4294967295
version 3.1
124
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS